|
|
|
|
Original Message
|
| top end oiling question..urgent |
| By dave - 04/26/2004 11:40:10 PM; IP 68.198.129.110 |
| I just installed a cut out valve cover on the L/H head and started the engine. Plenty of oil shooting out of hole for pushrod tips NOTHING comming out of holes for valve stem tips....is this normal? Are they splash oiled by what oil would reflect off the roof of the cover? These are new rocker shaft assys and I checked to make sure the oil holes on the rocker shaft were on the bottom. I also noted when I compared the replacement shafts to the ones I removed that there were an additional set of holes with chaamfered grooves on the originals that are not on the replacements. I have been trying to resolve an engine noise .....could this be it? |
|
|
This thread, so far...
|
|
|
|
Post A Response
|
|
|
|
|