Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Angle Milling By KarlJay - 02/01/2001 4:13:13 AM; IP 63.175.44.38 If the pistons are zero decked, I would either change the pistons or look elsewhere for more power. Unless you've already done that. Sounds like you have other perf parts, headers, intake, carb... If you've covered all the other bases, go ahead and mill the heads, a good speed shop should know just how far you can mill the heads. If they go too far, C8AE-H heads are cheap, just make sure you do a clay test first. Thicker head gaskets are another option, but with the price of those heads, I'd just grab another set.

This thread, so far...

Skip Navigation Links.  Angle Milling -- Bob, 01/31/2001  RE: Angle Milling -- Stanley Superior, 01/31/2001  RE: Angle Milling -- Bob, 01/31/2001  RE: Angle Milling -- Stanley Superior, 01/31/2001 RE: Angle Milling -- KarlJay, 02/01/2001

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 202523616 in the box