Skip Navigation Links Setup New Post Search Forum Home Home Decoder

Original Message

RE: Need opinions on over bore options By mike - 03/30/2001 11:48:30 PM; IP 12.87.104.120 we have sonic tested dozens of FE blocks and can safely say don"t do anything until you get the block sonic tested...we have had "standard" blocks sonic test too thin to even keep standard...many blocks need to be offset bored and/or sleeved in order to get any decent cylinder wall thickness..in any case use the smallest overbore piston you can get regardless of the cost as it's truly a false sense of economy to save $400 on pistons just to have the cylinder wall crack and destroy a typical $4,500. rebuild project. just my .02 from mike at ctmar.

This thread, so far...

Skip Navigation Links.  Need opinions on over bore options -- Eli, 03/23/2001  RE: Need opinions on over bore options -- James, 03/23/2001  Maybe you should tell use your intended use? -- Walker, 03/23/2001  RE: Maybe you should tell use your intended use? -- Eli, 03/23/2001  you don't need forged. The cast pistons should do -- Walker, 03/23/2001 RE: Need opinions on over bore options -- mike, 03/30/2001

Post A Response

Subcribe

Name: Email Address: Subject: Post: Upload Image: Human Check:   Enter the code 2025202229 in the box